Class C RV Dumping

In this video, we show you how to dump the 2019 Thor Freedom Elite. Please bare with us as it was so noisy when filming the instructions. Also we included a 22 step by step instructions on how to dump. For questions on dumping specific to this RV please comment below. Thank you. Dumping Instructions (while at dumping station): Step 1 – Turn off water pump (go to LED cluster inside the RV). Step 2 – Open the storage compartment door on driver rear side. Put on gloves, remove all items from black box, & remove (yellow) elbow from gray box. Step 3 – Connect stainless steel water hose to the water station and the other end to the RV’s SAN-T-FLUSH (do not turn on water yet). Step 4 – Remove black bumper cover, Pull out drainage hose from bumper. Step 5 – Connect drainage hose to (yellow) elbow. Step 6 – Place elbow on drainage hole at the dump station. Step 7 – Remove cover from Drain Outlet Connect, it will read Valterra (ensure all T handles are closed, pushed in). Step 8 - Connect drainage hose to RV’s Sewer Outlet Connection. Step 9 – Go to rear passenger side & reach under to open drainage (pull black T handle). Step 10 – Go to rear driver side and open drainage for black water (pull T handle) Black water will drain automatically. Wait for black water to stop flowing (lift drainage hose, a little, to feel the reduction of water weight). Step 11 – Close black water drainage (push in T handle) rear driver side only. Step 12 – Open gray water handle (pull T handle), Water will drain automatically. Step 13 – Go to main water station & open water (your turning on the water). Step 14 – Go back to Sewer Outlet Connection & feel for water reduction on the main drainage hose (lift drainage hose, a little, to feel the reduction of water weight). Once you feel that its empty, push in the gray T handle to close the gray water drainage. Step 15 – Wait a few minutes to fill the black water holding tank. You can check by going into the RV & looking at LED cluster & pushing the button for the black water tank. Step 16 – Once black water tank is full either by being notified by LED light indicating that its Full or looking directly into the toilet (Step on the toilet flush pedal to open the toilet hole & see inside to see where the water level is at. You won’t see the water flowing in). Step 17 – Once full, open the black water T handle, to allow the water to flow out, once empty, by feeling the weight of the hose, close the black T handle on the passenger side. Step 18 – Close the black T handle on the driver’s side. Step 19 - Disconnect the main drainage hose & place black cover on (Valterra) to seal drainage. Step 20 – Turn off water from water station & disconnect stainless steel hose from RV’s SAN-T- FLUSH, do not disconnect from water station. Step 21 – In this step, you need 2 persons: one to open the main water supply when the other person is ready to hold & rinse the main drainage hose from the end that connects to the RV. Water needs to flow through the main drainage hose to clean out. Once this is done, the main water supply is to be turned off. Disconnect stainless steel hose from water station. Step 22 – Stow away all items in their proper place, If both drainage hoses were used, be sure to split the hoses before replacing. Ensure that the rubber covers to the bumper are secured. Wash hands! #RV #ThorFreedomElite #ClassC