Farmhouse Console Table Build (FREE PLANS & dimensions in video/description) - NO TALKING, NO MUSIC
Materials: 2x6x8 (x5) 1x4x8 (x2) 1.25" & 2" screws 1.5" brad nails (or 1.25") Wood Glue Tools used in this video K4 Kreg Jig: https://amzn.to/3oq5fbt Bostitech nail gun: https://amzn.to/2KW64uT Dewalt miter saw: https://amzn.to/39oR2Y7 Jorgensen clamps: https://amzn.to/3j3FEnO Figure 8 fasteners: https://amzn.to/2KWtZKH HomeRight Paint Sprayer: https://amzn.to/2Mw81ii Freud forstner bit: https://amzn.to/2YnWMen Doweling jig: https://amzn.to/3aAg2v1 Festool parallel edge router guide: https://amzn.to/39tpsJo Cut list: TOP: Cut 3 of the 2x6x8s to 51.5" (I ripped the sides of each for square them up) LONG APRON: Use 2 of the remaining pieces from the top to cut the long apron - crosscut at 43.75" and then rip them to 2.5" (you will get 4 apron pieces out of this) SHORT APRON: Use the 3rd remaining extra piece from the legs rip this to 2.5", then crosscut to 10.5" (x4) LEGS: Take a new 2x6 and crosscut two 36" sections (72" overall + the blade width). Rip each section to 2.5" (take the rounded edges off too) - you will get 4 legs from this (you'll have ~24" left over - this can be used for a different project). DIAGONALS: Take a new 2x6x8 and crosscut to ~32" (or longer). Rip this piece into strips 1" wide. You'll only get 4 (possibly 5) strips out of this due to the blade width, so you'll have to crosscut another 32" section and repeat. You want 6 strips here. SHELF SLATS: I ripped the round edges off a 1x4x8 firring strip, and crosscut them to 11.5" long. ***Make your own measurement here - if you used a router for a shelf in the bottom apron, your measurement will be slightly different than mine. If you're just putting the slats on top of the bottom apron, you're measurement will be ~3"ish longer than mine. SIDE POCKET HOLE HIDING BOARDS - Use any piece of scrap to cut to the dimension to overlap this piece. I used valspar antique white painted with a Homeright Super Finish Max paint sprayer, with Minwax Special Walnut stain for the top, sealed with Minwax gloss polyurethane and then wipe on gloss polyurethane. Filmed with a GoPro Hero 6 Black, edited in iMovie. Thanks for watching! Be sure to subscribe for more upcoming videos and free plans! Check out my Instagram at MMCC_Woodshop for more of my work! *DISCLAIMER* The following content is for entertainment purposes only. Woodworking and using power tools can be extremely dangerous if not done properly. YOU (the viewer) are fully responsible for understanding proper use of tools, as well as the safety features of each. I highly suggest reading the owners manual and/or watching how-to videos on the tools. I (MMCC_Woodshop) am not responsible nor liable for any injury, death, or handing of the tools you may use, nor do I assume to display the proper handing of as a demonstration. Please use extreme caution when working with any power tools.
